How To Remove Sliding Closet Doors No Bottom Track

Most of the time the door will pop right off.

How to remove sliding closet doors no bottom track.

A common misconception is that closet door hardware especially hardware for sliding closet doors requires a bottom track. Then try lifting it up a little and pulling it towards you. Tilt the track backward slightly then pull it forward toward you to remove it. The floor guide keeps the doors level across the door opening.

Each door has its own track that spans the width of the closet opening. The belief is that the bottom track helps support the weight of the doors as well as keep the doors aligned. For horizontal adjustment on the bottom track lift the door from the bottom and move the adjusting wheel toward or away from the jam until the doors are plumb with the jam. The slider rails are tracks that hold the upper rollers of each sliding panel.

The sliding glass doors hug the wall on both sides of the opening saving space keep the whole room clean organized and flexible. How to remove sliding bypass closet doors from their track. At the bottom of the opening is a floor guide with two channels. A bypass closet features two doors that slide past each other.

Then angle the door towards you and pull gently detaching the door from its top track. There is no bottom track to step over. In less than 3 seconds the whole room can be closed off for privacy or opened up as wide as possible into a flowing space for a gathering. For vertical adjustment lift the door slightly until the adjustment wheel clears the slot in the lower bracket.

Be careful when pulling a door out of the track as many of the sliding doors can be quite heavy. Replacing sliding closet doors or making repairs to the upper rail requires getting the closet doors off the slider rails. Remove the outside closet door by first sliding the door to the center of the track. Next carefully lift the door up at a slight angle to remove the bottom rollers from the track.

Once this is complete repeat the process with the inside closet door. The johnson hardware that we supply with our closet doors is actually designed the other way around. Remove the screws holding the bottom track in place with a screwdriver. Lower the door back into the bracket when you re done.